Mechanical Cutting plywood

Cutting boards made, especially plywood / multiplex if not done properly will give unsatisfactory results. The outer layer is very thin veneer easily peeled off mainly by the effects of round saws when cutting is not done properly.
Cutting layoutStandard size plywood commonly used today are 2440 x 1220mm, and 1800 x 900mm. The composition of the fibers in both types of the same size, ie the direction of the length. Under these conditions, it is necessary to be well planned direction of cutting and cutting plywood STEP 2.
In production with a small amount of cutting layout is not the main priority. As for the factory that manufactures such as: office furniture, TV tables, wardrobes and kitchen cabinets in bulk, careful planning is needed.
Define the size and furniture parts you need and describe the layout of plywood. Find the first component that has the greatest width (eg top table) describe a new board of smaller components.Try to keep the component which has a width equal or close to being in one groove to the long direction. The aim is that the division process is faster and produces plywood pieces of good results and smooth.
Tips on cutting plywood1. Avoid cutting the transverse direction of fiber veneer. In addition to less efficient will also be at risk of rough cut ends.2. Use saw blades with konfirgurasi eye that is suitable for plywood. Saw blade for plywood usually have a combination of the composition, angle and a certain number of pieces to optimize results.3. If you cut a circle using a Table Saw: Put on a good surface.4. If you cut using a Portable Circle Saw: Put a good surface below.5. Cut one long side and the side section width (± 10 mm) to smooth the outer side of the plywood in order to have a good line of pieces. Not all plywood came from the factory has a straight outer side and also there is usually a defect because of the impact at the time of delivery.6. Attach masking tape along the cut line so as not to hold the veneer peeling. This method is not recommended for deep cuts in emissions because it will slow the process. For small quantities and high quality products are highly recommended.7. Attach a long piece of solid wood boards or plywood on the bottom of the sheet to be cleaved. This is the same functions with tape but more robust and stable.For the same purpose can also be done using a knife cut veneer top cutter or nail so that the wood fibers are not damaged.